NEC Univerge SV8100 Features And Specifications Manual page 1652

Issue 13.0
Program
Program Name
Number
10-03-06 ETU Setup (DTI (T1) PKG Setup)
– Number of Ports
10-09-01 DTMF and Dial Tone Circuit
Setup
10-39-01 Fractional Setup – Fractional
14-01-02 Basic Trunk Data Setup –
Transmit Level
14-01-03 Basic Trunk Data Setup –
Receive Level
14-01-07 Basic Trunk Data Setup –
Outgoing Calls
2 - 1618
Description/Comments
Set up and confirm the basic
configuration data for the number
of ports required.
For ANI/DNIS, reserve at least
one DTMF receiver for DTMF
reception (entry 0 or 2).
Use the following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one
DTMF receiver for every 10
devices that use them.
In heavy traffic sites, allocate one
DTMF receiver for every five
devices that use them.
Enable/Disable T1/PRI fractional
function.
Select transmit level of CODEC
Gain (signal amplification) for each
trunk.
Select receive level of CODEC
Gain (signal amplification) for each
trunk.
Allow/Deny outgoing calls on the
trunk you are programming.
T1 Trunking (with ANI/DNIS Compatibility)
UNIVERGE SV8100
Assigned Data
1
0 = Auto
1 = 4 Ports
2 = 8 Ports

3 = 12 Ports
4 = 16 Ports
5 = 20 Ports
(default = 0)
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
0 = Disable
1 = Enable
(default = 0)
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
0 = Deny (No)
1 = Allow (Yes)
(default = 1)
Level
2 3




