Figure 2-23 G566 And G266 In Desktop Charger - NEC Univerge SV8100 Features And Specifications Manual

UNIVERGE SV8100
Powering the AP400/AP300
The AP400/AP300 can only be powered using Power over Ethernet (PoE) 802.3af. A PoE switch is a
switched hub that also provides power over the spare pairs. The switch can be used with other devices
than the IP telephones and detects whether or not power is needed. Using a PoE switch makes it easier
to protect the IP telephones from loss of power (connection of the PoE switch to an UPS).
Updating the AP400 and ML440/G566/G266 System Firmware
The firmware on base stations and handsets is updated remotely using the HTTP configuration interface
to download firmware files from a TFTP server. Updating base station firmware involves an automatic
reboot of the base station at the end of the firmware download. This will drop any active calls and in
addition updating the handset firmware can take several hours. It is recommended updates are
performed after normal business hours. Refer to the UNIVERGE SV8100 IP-DECT Customer Engineer
Manual for additional information.
Conditions
DAP Manager Version 6.00 or higher is required to support AP400 Access Points and

ML440 handsets.
The ML440 handset requires AP400 Access Points.

The DAP manager does not supp

Only AP400 and AP300 DAPs are supported for ML440/G566/G266 handsets.

The AP400/AP300 with ML440/G566/G266 handsets are not supported behind NAT

routers.
IP Multiline Station (SIP) – ML440/G566/G266 with AP400/AP300

Figure 2-23 G566 and G266 in Desktop Charger

ort Internet Explorer 10 (IE 10).
Issue 13.0
2 - 815