NEC Univerge SV8100 Features And Specifications Manual page 1011

UNIVERGE SV8100
Only one PZ-32IPLA/IPLB, PZ-64IPLA/IPLB or PZ-128IPLA/IPLB daughter board can be installed on the
CD-CP00-US.
The PZ-32IPLA/IPLB, PZ-64IPLA/IPLB or PZ-128IPLA/IPLB daughter board has Layer2 Switch ability,
along with a Gigabit Ethernet LAN interface and RTP/RTCP packet is transmitted and received directly.
The number of ports supported by the IP K-CCIS (Peer to Peer) application depends on which
PZ-( )IPLA/IPLB is installed on the CD-CP00-US and on the number of ports licensed in the
CD-CP00-US. For example, if the CD-CP00-US is installed with a PZ-64IPLA/IPLB, the maximum
configuration supported by the CCISoIP application is 64 CCISoIP channels.
Conditions
A maximum of 200 IP Trunks are supported in the SV8100, but the maximum number of

simultaneous talk paths depend on the size and available channels of the IPLA/IPLB unit.
When using ARS Class of Service Matching, CCIS calls always follow Class of Service 1.

UCB is not supported for Centralized Voice Mail.

With Version 3100 (3.13 or higher) CPU software, if single lines for fax machines are set

to Special (Program 15-03-03), faxing across IP CCIS will always use G.711 codec.
When using InMail in a CCIS or Netlink network, 8-digit extensions and mailboxes are not

supported.
When connecting a SV8100 to a NEAX PBX, Link reconnect needs to be turned off in the

PBX to the SV8100.
The CCISoIP Fax Enhancement feature requires Version 5000 or higher software, the

PZ-IPLB32/64/128 VoIPDB and the Version 5000 Enhancement license.
The CCIS Call Back feature requires Version 5000 or higher software and the Version

5000 Enhancement license.
The CCISoIP Fax Enhancement feature supports G.711, G.726 and T.38 between two

SV8100s.
When using the CCISoIP Fax Enhancement feature between a SV8100 and a SV8300/

SV8500, refer to the documentation for the SV8300/SV8500 system software level to
determine if the desired Fax CODEC is supported and for information on setting up the
feature on that system.
When connecting to a SV8300 or SV8500 using K-CCIS the Call Back feature is not

supported.
The CCIS Call Back feature is only supported when using a closed numbering plan.

The CCIS Call Back feature is not supported on K-CCIS – PVA.

CCIS Call Back can only be set when the destination party is busy, and the calling party

hears a busy tone.
K-CCIS – IP
Issue 13.0
2 - 977