NEC Univerge SV8100 Features And Specifications Manual page 983

UNIVERGE SV8100
Program
Program Name
Number
20-09-03 Class of Service Options
(Incoming Call Service) – Sub
Address Identification
20-11-11 Class of Service Options (Hold/
Transfer Service) – Automatic
On-Hook Transfer
20-11-14 Class of Service Options (Hold/
Transfer Service) –
Trunk-to-Trunk Transfer
Restriction
20-11-21 Class of Service Options (Hold/
Transfer Service) – Restriction
for Tandem Trunking on Hang Up
20-13-23 Class of Service Options
(Supplementary Service) –
Display the Reason for Transfer
20-19-04 System Options for Caller ID –
Wait Facility IE Timer
20-25-14 ISDN Options – No response
Release Send
ISDN 2 B-Channel Transfer:
Program
Program Name
Number
10-03-16 ETU Setup – PRI Service Two B-
Channel Transfer
14-01-13 Basic Trunk Data Setup – Trunk-
to-Trunk Transfer
ISDN Compatibility
Description/Comments
Define whether or not an
extension displays the Caller Sub-
Address.
Turn Off or On an extension user
ability to transfer when the user
hangs up.
Turn Off or On the Trunk-to-Trunk
Transfer Restriction. If enabled,
Trunk-to-Trunk Transfer is
impossible.
Allow an extension user to set up
a tandem call automatically when
they hang up.
Select whether or not an extension
should display the reason a call is
being transferred to their
extension (Call Forward Busy, Call
Forward No Answer, DND).
This is the time an ISDN trunks
uses to determine the time the
system waits for the Caller ID
name from the Telco.
Operation mode setting for when
second T303 timer expires.
Description/Comments
Turn On or Off the ability to use
the ISDN-PRI 2 B-Channel
Transfer service.
If DISA caller can place outgoing
calls through the system (refer to
Program 20-14 in the Electra Elite
IPK II Programming Manual),
Enable loop supervision for the
DISA trunk. If DISA caller cannot
use the system trunks for outgoing
calls, enter Disable.
Assigned Data
1
0 = Deny
1 = Allow
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Allow
1 = Deny
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0~64800 (seconds)
(default = 10)
0 = Off
1 = On
(default = 0)
Assigned Data
1
0 = Off

1 = On
(default = 0)
0 = Disable
1 = Enable
(default = 1)

Issue 13.0
Level
2 3







Level
2 3
2 - 949