NEC Univerge SV8100 Features And Specifications Manual page 1014

Hide thumbs Also See for Univerge SV8100:

Table of Contents

Table 2-58 K-CCIS Main and Remote System VoIP Resources Used (Continued)

The number in

each box indicates

how many VoIP

resources are used

M = Main K-CCIS System

R = Remote K-CCIS System

Main software Version 4000 (4.01 or higher) and the Version 4000 Main Version license

is required for the SV8100 to support Peer to Peer in a CCISoIP network.

DT700 terminals are supported for Peer to Peer connections via a P2P CCIS call.

Standard SIP terminals are not supported for Peer to Peer connection.

If either Programs10-26-04 or 50-15-04 are set to 0 (Disable) in system A, Peer to Peer is

disabled for system A and any remote systems when calling system A.

When port translation is done through a NAT router, Peer to Peer is disabled.

When RTP encryption is enabled, Peer to Peer is disabled.

When connecting to a SV8300 or SV8500 using CCISoIP, Program 84-21-21 must be set to

When connecting to other SV8100s using CCISoIP, Program 84-21-21 must be set the

same in all systems.

SV8100 K-CCIS-IP to another SV8100, for calls from an IP terminal to a TDM terminal/

trunk via Peer to Peer, the IP Terminal's Codec must match the CCIS Codec and the packet

size is auto negotiated based on the receiving sides packet size.

SV8100 K-CCIS-IP to another SV8100 or to a NEAX PBX (SV8300, SV8500, etc.), for calls

from an IP terminal to another IP terminal/trunk via Peer to Peer, the IP Terminal's Codec

must match and the packet size is auto negotiated.

SV8100 K-CCIS-IP to a NEAX PBX (SV8300, SV8500, etc.), for calls from an IP terminal to

a TDM terminal via Peer to Peer, the IP Terminal's Codec and packet size (Program

84-24-XX) need to match the NEAX PBX CCIS Codec and packet size settings.

With SV8100 Version 5000 (5.00 or higher) software and PZ-IPLB daughter board

installed, half duplex connections are not supported. For troubleshooting purposes, a

managed switch capable of port mirroring is required to capture packet data from the

SV8100 IPLB Ethernet port.

UNIVERGE SV8100

Remote System