Fog Light Assembly; Fog Light Adjustment; Side Marker Light Bulb - Isuzu 1999 RODEO Workshop Manual

LIGHTING SYSTEM
8A–4
Removal
1. Disconnect the battery ground cable.
2. Remove the fog light assembly (1).
f Disconnect the connector.
f Remove two nuts from the bracket.
Installation
To install, follow the removal steps in the reverse order.
CAUTION: After installing the fog light, be sure to
adjust the fog light aim.
Removal
1. Disconnect the battery ground cable.
2. Remove the radiator grille.
f Refer to Engine Hood and Fender in section.
3. Remove the front combination light (2).
f Remove three screws.
4. Remove the bulb (1).
f Remove the side marker light socket by turning it
counterclockwise.
f Remove the bulb by turning it counterclockwise
while pushing it at the same time.

Fog Light Assembly

Fog Light Adjustment

Vertical Adjustment
Turn the adjusting screw with a screwdriver to adjust the
aim of the fog light vertically.
825RW092

Side Marker Light Bulb

Installation
To install, follow the removal steps in the reverse order.
825RW065
825RW067