Isuzu 1999 RODEO Workshop Manual page 2024

MANUAL TRANSMISSION
7B–58
Clutch Hub Spline Play
f Set a dial indicator to the clutch hub to be measured.
f Move the clutch hub as far as possible to both the right
and the left.
Note the dial indicator reading.
If the measured value exceeds the specified limit, the
clutch hub must be replaced.
Clutch Hub Spline Play
Standard
1st–2nd
0 – 0.1 mm
(0 – 0.004 in)
3rd–4th
0 – 0.2 mm
Rev. 5th
(0 – 0.008 in)
Ball Bearing Play
f Use a dial indicator to measure the ball bearing play.
Ball Bearing Play
Limit: 0.2 mm (0.008 in)
Reassembly
226RS042
1. Install center roller bearing(29) to counter gear
shaft(30).
f Apply engine oil to the bearing inner and outer
circumferences.
f Install the roller bearing in the proper direction.
NOTE: Check that outer race moves only in the direction
of arrow.
Limit
0.2 mm
(0.008 in)
0.3 mm
(0.012 in)
2. Install front roller bearing(28) by performing the
following steps.
f Use bearing installer to install the front roller
bearing inner race to the counter gear shaft.
f Install the outer race and roller assembly.
The snap ring groove must be facing the
transmission front side.
226RS043
226RS044