Isuzu 1999 RODEO Workshop Manual page 1979

MANUAL TRANSMISSION
27. Turn the remover to separate the release bearing
(6VD1 engine).
28. Remove transmission retaining nuts and bolts(20).
Remove transmission(21) from the vehicle.
Installation
1. Apply a thin coat of molybdenum disulfide grease to
the top gear shaft spline.
2. Slowly operate the transmission jack until the front of
transmission is aligned with the rear of the engine.
The slope of the engine and the transmission must be
the same.
3. Align the top gear shaft spline with the clutch driven
plate spline.
220RS003
7B–13
220RS004
220RS007