Isuzu 1999 RODEO Workshop Manual page 2065

f Check the housing bore alignment by:
– Mounting the dial indicator against the bore
– Rotating the engine one revolution while recording
total dial indicator needle travel
f Check the housing face alignment by:
– Mounting the dial indicator against the housing
face
– Rotating the engine one revolution while recording
total dial indicator needle travel
If either reading is greater than 0.254 mm
(0.010 inch), place special shims between the engine
and clutch housing to correct the misalignment.
MANUAL TRANSMISSION
4. Check the condition of these clutch system parts if
you suspect excessive wear:
f Pressure plate assembly
f Driven disc (especially the torsional damping
springs)
f Flywheel
f Input shaft pilot bearing.
201RS032
Replace any parts which have excessive wear.
5. Reassemble the clutch system parts. Be sure to
lubricate the clutch release bearing bore and fork
groove and also the head of the fork pivot.
201RS033
7B–99
015RS076