Fuel Tank Pressure Sensor - Isuzu 1999 RODEO Workshop Manual

6E2–482
RODEO 6VD1 3.2L ENGINE DRIVEABILITY AND EMISSIONS
3. Slide the out of EVAP canister vent solenoid from
mounting bracket.
Inspection Procedure
1. Check for cracks or leaks.
2. Energize the solenoid and try to blow through it. The
solenoid should not allow passage of air when
energized. (J 35616 Connector Test Kit can be used
to easily attach jumper wires from the battery to the
solenoid).
Installation Procedure
1. Slide the into EVAP canister vent solenoid from
mounting bracket.
2. Connect the connector and hose.
3. Connect the negative battery cable.
014RW135

Fuel Tank Pressure Sensor

Removal Procedure
1. Remove the fuel pump assembly. Refer to Fuel Tank
In Fuel Pump .
2. Carefully pry the fuel tank pressure sensor out of the
top of the fuel pump assembly.
Inspection Procedure
1. Inspect the vapor pressure sensor for cracks in the
014RW135
housing and corrosion on the electrical terminals.
2. Inspect the rubber grommet for tears and signs of rot.
014RW132
014RW133