Installation - Isuzu 1999 RODEO Workshop Manual

13. Remove select cable by disconnecting inner cable
from select lever and removing outer cable with
bracket.
14. Remove starter.
15. Remove flywheel under covers from the transmission
and engine.
16. Remove transfer control lever fixing bolts and push up
transfer control lever.
AUTOMATIC TRANSMISSION (4L30–E)
17. Remove flywheel-torque converter fixing bolts (6
pieces) by turning crankshaft.
18. Remove engine-transmission fixing bolts.
256RW025
19. Pull out transmission from the engine.

Installation

1. Slowly raise transmission jack until front of the
transmission is aligned with rear of the engine. Join
the transmission to the engine.
2. Tighten engine-transmission bolts as shown in the
figure.
262RW015
7A–39
240RW005