Catalytic Converter; Air Conditioning Relay; Evap Canister Hoses - Isuzu 1999 RODEO Workshop Manual

2. Install the coil module and spark plug boot over the
spark plug.
3. Secure the coil module to the rocker cover with two
screws.
4. Connect the electrical connector at the coil module.
5. Connect the negative battery cable.

Catalytic Converter

Removal and Installation Procedure
Refer to Engine Exhaust in Engine .
RODEO 6VD1 3.2L ENGINE DRIVEABILITY AND EMISSIONS
014RW108
014RW091

Air Conditioning Relay

Removal Procedure
1. Remove the fuse and relay box cover from under the
hood.
2. Consult the diagram on the cover to determine which
is the correct relay.
3. Pull the relay straight up and out of the fuse and relay
box.
Installation Procedure
1. Insert the relay into the correct place in the fuse and
relay box with the catch slot facing forward.
2. Press down until the catch engages.
f An audible "click" will be heard.
3. Install the fuse and relay box cover.

EVAP Canister Hoses

Service Information
To view the routing of the EVAP canister hoses, refer to
Vehicle Emission Control Information in Diagnosis . Use
6148M or equivalent when you replace the EVAP canister
hoses.
6E2–479
014RW090