Isuzu 1999 RODEO Workshop Manual page 2435

BODY STRUCTURE
8F–10
11. Remove front fender panel.
f Disconnect 8 fixing bolts.
Installation
To install, follow the removal steps in the reverse order
noting the following points:
1. Tighten the front fender panel fixing bolts to the
specified torque.
Torque : 6.5 N·m (56 lb in)
2. Tighten the engine hood fixing bolts to the specified
torque.
Torque : 9.8 N·m (85 lb in)
3. Adjust the clearance between the each of the panels.
f Check the fender and front door (3).
614RX001
Clearance : 5.0 mm (0.196 in)
Height (step) : Flush
f Check the front door and rear door (2).
Clearance : 6.0 mm (0.23 in)
Height (step) : Flush
f Check the rear door and body (1).
Clearance : 5.0 mm (0.196 in)
Height (step) : Flush
Adjust clearance with door hinges.
Adjust height (step) by tapping on the fender lightly
with a rubber hammer.
610RW005
610RW001