Isuzu 1999 RODEO Workshop Manual page 1853

7. Remove retaining washer (3), bearing (4), thrust
washer (5), and clutch plates (6 and 7) from the third
clutch drum assembly (8).
Inspection and Repair
Visual Check:
If any damage, deformation or wear is found, replace the
damaged part.
Reassembly
1. Place third clutch drum and intermediate shaft
assembly upright, using the overdrive internal gear as
a support.
2. Install third clutch spring cushion plate (7), bevel face
down.
3. Install third clutch plates (6) into third clutch drum
assembly (8). Start with the steel clutch plate and
alternate with lined plates.
4. Install thrust washer (5), bearing (4) and retaining
washer (3).
5. Fully engage the hub spline of the input sun gear and
sprag unit assembly (2) into the third clutch inner
tangs.
f Simultaneously rotate the outer sprag race to
engage into the third clutch drum assembly (8).
Disassembled View
Legend
(1) Retaining Ring
(2) Spring Seat
AUTOMATIC TRANSMISSION (4L30–E)
6. Place J-38450-A blades between the retaining ring
and the third clutch drum apporximately (five)
notches apart, and one blade at each end of the
retaining ring (1). Push down on sprag assembly until
the assembly is seated into the third clutch drum
assembly (8).
7. Remove the tool blades and engage retaining ring
into groove of third clutch drum.
Third Clutch
(3) Springs
(4) Piston Assembly
(5) Third Clutch Drum
7A–71
248RX002
248RS006