Isuzu 1999 RODEO Workshop Manual page 2573

9J1–12 RESTRAINT CONTROL SYSTEM
Chart C "AIR BAG" Warning Lamp Does Not Comes "ON" Steady (Cont'd)
Step
9 1. Disconnect SRS coil and passenger air bag assemblies.
Yellow 2–pin connectors located at base of steering column
and behind the glove box assembly.
2. Disconnect SDM.
3. Replace "MA01" meter fuse.
4. Ignition switch "ON" wait to 10 seconds.
5. Ignition switch "OFF".
6. Remove and inspection "MA01" meter fuse.
Is fuse good?
10 Reconnect all SRS components, ensure all components are
properly mounted.
Was this step finished?
Action Yes
Replace SRS
Install "MA01" Replace"MA01"
meter fuse. meter fuse.
Go to Chart A. Go to Step 10
Repeat the "SRS
Diagnostic
System Check."
Go to Step 10
No
harness.