Isuzu 1999 RODEO Workshop Manual page 2001

NOTE: The snap ring must be fully inserted into the
transfer case snap ring groove.
7. Install front output gear assembly(24).
8. Use a pair of snap ring pliers to install the snap ring
(23) to the transfer case(28).
NOTE: The snap ring must be fully inserted into the
transfer case snap ring groove.
9. Install plate(22), ball(21), bearing collar(20), needle
bearing(19), and transfer input gear(18).
10. Install High-low clutch hub and sleeve(17).
The clutch hub face (with the heavy boss) must be
facing the transfer input gear side.
11. Install the front companion flange temporarily.
f Use the flange holder J–8614–11 and lock nut
wrench J–37219 to install the lock nut(16).
Torque: 137 N·m (101 lb ft)
MANUAL TRANSMISSION
12. Use the punch to stake the lock nut at one spot.
13. Use a suitable drift and hammer to install the ball
bearing(15).
226RW152
14. Use a pair of snap ring pliers to install the bearing
snap ring(14).
15. Regarding detent, shift arm, and interlock pin(13)
assembly, refer to Detent, Shift Arm, and Interlock Pin
in Drive Line/Axle section.
7B–35
226RS068
226RS079