Isuzu 1999 RODEO Workshop Manual page 1774

6G–10 ENGINE LUBRICATION (6VD1 3.2L)
f Use J-39202 installer when installing new oil seal.
f Apply engine oil to oil seal lip.
f Install oil pump assembly to the cylinder block.
NOTE: Do not damage oil seal during installation of oil
pump assembly.
f Tighten fixing bolts to the specified torque.
Torque : 25 N·m (18 lb ft)
2. Install oil pipe with O-ring, tighten fixing bolt to the
specified torque.
Torque : 10 N·m (89 lb in)
3. Install oil strainer with O-ring, tighten fixing bolt to the
specified torque.
Torque : 25 N·m (18 lb ft)
4. Install oil filter assembly and tighten bolts to the
specified torque.
Torque : 25 N·m (18 lb ft)
015RS001
Legend
(1) Oil Pump
(2) Oil Filter
(3) Oil Gallery
(4) From Oil Filter
(5) To Oil Filter
5. Install timing pulley on crankshaft.
Install timing belt.
f Refer to installation procedure for Timing Belt in this
manual.
6. Install crankshaft pulley.
f Refer to install procedure for Crankshaft Pulley in
this manual.
7. Install crankcase assembly.
f Refer to installation procedure for Oil Pan and
Crankcase in this manual.
051RW001
8. Refill engine oil until full level on engine oil dipstick.
050RW001