Isuzu 1999 RODEO Workshop Manual page 2039

f Look for worn edges on these parts:
– Selector arm
– Interlock plate
– Selector plates for the 1–2 and 3–4 shift forks
– 5–R shift lever and the rollers on the reverse fork
and the 5th shift rail/fork.
MANUAL TRANSMISSION
f Look for worn mating surfaces on the following
parts:
– 1–2 shift fork, pads and synchronizer sleeve
– 3–4 shift fork, pads and synchronizer sleeve
230RS021
– 5th shift rail/fork, pads and synchronizer sleeve
– Reverse fork and the mating sleeve surface of the
reverse idler gear.
6. Inspect the following bearings for excessive wear:
f Crankshaft pilot bushing for the front of the input
shaft
f Clutch release bearing
f Input shaft bearing
f Mainshaft pilot bearing rollers
f Mainshaft thrust bearing and its mating surfaces
230RS022
7B–73
226RS114
226RS115