Front Oil Seal (Converter Housing); Removal; Installation; Rear Oil Seal (Extension Housing) - Isuzu 1999 RODEO Workshop Manual

7A–50 AUTOMATIC TRANSMISSION (4L30–E)

Removal

1. Remove transmission assembly from the vehicle
,refer to Transmission in this section.
2. Remove torque converter from converter housing.
3. Remove three screws and oil seal ring from converter
housing.
Removal
1. Remove transfer case assembly from the vehicle.
Refer to Transfer Case in Drive Line/Axle section.
2. Remove rear oil seal from transmission extension
housing.

Front Oil Seal (Converter Housing)

241RW008

Rear Oil Seal (Extension Housing)

241RW005

Installation

1. Apply clean ATF to the new oil seal ring lip.
f Install oil seal ring to converter housing, tighten to
the specified torque.
Torque: 3 N m (26 lb in)
2. Install torque converter to converter housing.
3. Install transmission assembly case to the vehicle,
refer to Transmission in this section.
Installation
1. Use J–36797 extension housing oil seal installer, and
install the rear oil seal to the transmission extension
housing.
2. Install the transfer case assembly to the vehicle.
Refer to Transfer Case in Drive Line/Axle section.