Powertrain Control Module (Pcm); Removal; Installation - Isuzu 1999 RODEO Workshop Manual

7A–48 AUTOMATIC TRANSMISSION (4L30–E)

Removal

1. Disconnect battery ground cable.
2. Remove transfer control lever knob, lower cluster
assembly, center console and front console.

Installation

1. Install two brackets to PCM.
2. Install four PCM retaining screws.
3. Connect PCM wiring harness connectors to PCM.
4. Install center console, rear console, lower cluster
assembly and transfer control lever knob.
5. Connect battery ground cable.

Powertrain Control Module (PCM)

3. Disconnect PCM wiring harness connectors from
PCM.
4. Remove four PCM retaining screws.
5. Remove two brackets from PCM.
828RW003