Install the release bearing (4) in the proper direction.
NOTE: Ensure release bearing is properly positioned
during installation, as shown in the figure.
6. Use the pilot aligner J–24547 to install the driven plate
assembly (3).
7. Tighten the bolts holding the pressure plate assembly
(2) in the order shown in the figure.
Torque: 18 N·m (13 lb ft)
201RS019
8. Remove the aligner.
NOTE: Do not strike the aligner with a hammer to remove
it.
9. Install transmission assembly to the engine.
201RS016
CLUTCH
7C–25
201RS017