Isuzu 1999 RODEO Workshop Manual page 2090

Rivet Head Depression
Use a depth gauge or a straight edge with steel rule to
measure the rivet head depression (1) from the facing
surface (2).
Be sure to measure the rivet head depression on both
sides of the driven plate. If the measured value is less
than the specified limit, the facing must be replaced.
Rivet Head Depression
Standard: MIN 1.3 mm (0.051 in)
Limit: 0.2 mm (0.008 in)
Pressure Plate Assembly
Check the cover for cracks and distortion, and the
diaphragm spring for heat distortion, loosened rivets.
Check the diaphragm spring for wear.
201RS009
Installation
1. Clean and lubricate with grease.
2. Use installer J–1522 to install crankshaft bearing (6).
X22SE
201RS010
CLUTCH 7C–15
201RS047
015RS078