Isuzu 1999 RODEO Workshop Manual page 1820

7A–38 AUTOMATIC TRANSMISSION (4L30–E)
5. Remove fuel pipe heat protector and clip.
6. Disconnect transmission harness connector and clip.
Connector : Adapter case, mode switch, main case,
magnetic sensor, transfer switch (4 4), 2–4 actuator
(4 4) and car speed sensor.
7. Remove harness heat protector.
8. Support transmission with a jack.
Remove rear mount nuts from 3rd crossmember.
141RW004
9. Remove third crossmember.
10. Disconnect transmission oil cooler pipes from A/T
side.
11. Remove oil pipe clamp and bracket from the
converter housing.
815RW002
12. Loosen oil cooler pipe clamp bolt at the engine mount
side.
F07RW008
253RW001