Knock Sensor (Ks) - Isuzu 1999 RODEO Workshop Manual

6E2–454
RODEO 6VD1 3.2L ENGINE DRIVEABILITY AND EMISSIONS
4. Disconnect the electrical connector from the IAT
sensor.
5. Remove the IAT sensor from the intake air duct by
using a rocking motion while pulling the sensor.
Installation Procedure
1. Install the IAT sensor into the grommet in the intake
air duct.
2. Correct the IAT electrical connector.
3. Install the engine cover.
4. Connect the negative battery cable.

Knock Sensor (KS)

Removal Procedure
1. Disconnect the negative battery cable.
2. Drain the cooling system. Refer to Draining and
Filling the Cooling System in Engine Cooling .
3. Remove the engine cover.
4. Remove the common chamber assembly.
Refer to Common Chamber in Engine Mechaical.
TS23741
5. Disconnect the electrical connector from the knock
sensor.
TS23741
6. Unscrew the knock sensor from the engine block.
014RW106
014RW103