Isuzu 1999 RODEO Workshop Manual page 1843

f Ensure free rotation of pump using J–23082–01
pump rotation tool.
38. Overdrive clutch end play measurement.
1. Fit J–25022 and J–24773–1 turbine shaft puller
on turbine shaft.
2. Position axial play checking tool on converter
housing mating face.
3. Pull turbine shaft upwards with puller until first
resistance is met. (due to weight of overdrive
assembly)
4. Maintain shaft in this position and set indicator to
zero.
5. Pull turbine shaft further upwards with puller.
Read end play shown on indicator.
End play: 0.1mm – 0.8mm (0.004 in – 0.031in)
6. Remove axial play checking tool and puller.
AUTOMATIC TRANSMISSION (4L30–E)
NOTE: If end play is not correct, repeat selective washer
selection.
39. Inspect extension housing oil seal and replace if
necessary, using J–36797 extension housing oil seal
installer.
f Rotate transmission to horizontal position, with
valve body side down.
f Inspect parking wheel seal ring.
necessary.
f Install wheel parking lock assembly (35).
40. Install speed wheel (36) and snap ring (37). (4 4)
241RW010
NOTE: Use extra long, needle nose pliers.
Install flange, O–ring and nut. (4 2)
41. Install gasket onto extension assembly with a thin
coating of oil.
f Install extension housing assembly (38), and align
parking pawl shaft.
f Install actuator assembly into extension assembly.
f Install seven 8 mm hexagon socket head screws.
Torque: 32 N m (24 lb ft)
42. Inspect speed sensor O-ring. Replace if necessary.
f Install speed sensor assembly (39) and 10 mm
screw.
Torque: 9 N m (78 lb in)
7A–61
252RW001
Replace if