Dtc P0758 Shift Solenoid B Electrical - Isuzu 1999 RODEO Workshop Manual

DTC P0758 Shift Solenoid B Electrical

Circuit Description
f The shift solenoid B is a simple on/off solenoid
located in the main case valve body. It is normally
open. When the port is open, fluid pressure actuates
the shift valve. In first or second gear, the Powertrain
Control Module (PCM) energizes the solenoid to
close a fluid inlet port.
f The solenoid is activated by current. This current is
produced by applying a voltage to one side (the High
side) and a ground to the other side (Low side).
f The High Side Driver (HSD) is a circuit of the PCM
that acts as a switch between the solenoids and the
supply voltage. The High side of the solenoid is
permanently supplied with voltage. In BACKUP
MODE or when the ignition is off, the HSD is turned
off.
This DTC detects a continuous open or short to ground in
the shift solenoid B circuit or shift solenoid B. This is a
type "B" DTC.
Conditions For Setting The DTC
f Ignition is "on", Engine "run".
f Battery voltage is between 10 and 16 volts.
f The PCM commands the solenoid "on" and the
voltage remains high (B+), or the PCM commands
the solenoid "off" and the voltage remains low (zero
volts).
f All conditions met for 0.33 seconds.
TRANSMISSION CONTROL SYSTEM (4L30–E)
Action Taken When The DTC Sets
f Fixed to 4th gear.
f Maximum line pressure.
f Inhibit TCC engagement.
f The PCM will illuminate the Malfunction Indicator
Lamp (MIL) and CHECK TRANS Lamp.
Conditions For Clearing The MIL/DTC
f The PCM will turn off the MIL and CHECK TRANS
Lamp after three consecutive ignition cycles without a
failure reported.
f The DTC can be cleared from the PCM history by
using a scan tool.
f The DTC will be cleared from history when the vehicle
has achieved 40 warmup cycles without a failure
reported.
f The PCM will cancel the DTC default actions when
the fault no longer exists and the ignition is cycled "off"
long enough to power down the PCM.
Diagnostic Aids
f Inspect the wiring for poor electrical connections at
the PCM and at the transmission 16–way connector.
Look for possible bent, backed out, deformed or
damaged terminals. Check for weak terminal tension
as well. Also check for a chafed wire that could short
to bare metal or other wiring. Inspect for a broken wire
inside the insulation.
7A1–71
D07RW014