Removal; Installation - Isuzu 1999 RODEO Workshop Manual

Removal

1. Disconnect the battery ground cable.
2. Remove rear corner garnish.
3. Remove courtesy light lens.
4. Remove window regulator handle.
f Remove the clip on the rear side of the regulator
handle using a wire.
5. Remove the screw while pulling the inside lever
toward you and then remove the inside handle.
6. Remove the 2 screws at the pull case and courtesy
light.
7. Pull out the trim panel at the 8 clip positions.
f Disconnect the power window switch connector
and courtesy light connector.
8. Remove power window switch, if equipped.
9. Remove bracket.
10. Remove waterproof sheet.
f Taking notice of the door harness, peel the
waterproof sheet off the door panel carefully.
11. Disconnect the locking links and remove the door lock
assembly fixing screws to remove the door lock
assembly.
651RW003

Installation

To install, follow the removal steps in the reverse order,
noting the following points.
1. Apply chassis grease to the lock assembly and striker
moving surface.
2. Install the regulator handle as shown in the
illustration, if equipped without power windows.
655RW003
3. Check that the door lock operates smoothly.
SECURITY AND LOCKS 8H–7
655RW002
631RW005