Isuzu 1999 RODEO Workshop Manual page 2611

10A–4 CRUISE CONTROL SYSTEM
Actuator Cable Diagram
Legend
(1) Cruise Actuator Assembly
(2) Cruise Control Cable
Removal
1. Disconnect the battery ground cable.
2. Remove the cruise actuator assembly (4).
f Disconnect the connector (3).
f Remove the cable end (1) from the throttle link
(cruise control side).
f Loosen two fixing nuts (2).
f Remove three actuator assembly fixing screws.
Cruise Actuator
(3) Accelerator Cable
(4) Throttle Link (Cruise Control Side)
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
1. Take care not to bend the cable excessively.
Adjustment
After installing the cruise actuator, the following steps
must be carried out for cruise control cable adjustment.
1. Install the cruise control cable end (3) to the throttle
link (4).
2. Put the screw portion of the cable in the bracket (5).
3. Put the nut (1) to the bracket and then tighten the nut
(2).
825RW049
825RW093