Valve Body Assembly (Adapter Case); Removal; Installation - Isuzu 1999 RODEO Workshop Manual

10. Install oil filter and three 13 mm screws. Tighten to the
specified torque.
Torque : 20 N m (15 lb ft)
11. Install oil pan gasket, magnet, oil pan and sixteen 10
mm screws. Tighten the screws to the specified
torque.
Torque: 11 N m (96 lb in)

Removal

1. Raise the vehicle and support it on jack stands.
2. Disconnect battery ground cable.
3. Drain fluid.
4. Remove twelve 10 mm adapter case oil pan fixing
screws, adapter case oil pan, and gasket.
NOTE: Oil pan still contains transmission fluid. Place a
large drain container under the oil pan.
Drain the fluid carefully.
5. Disconnect wiring harness from force motor solenoid
and converter clutch solenoid. Pull only on
connectors, not on wiring harness.
6. Remove seven 13 mm screws from adapter case
valve body assembly, then remove transfer plate, two
gaskets, and adapter case valve body.

Installation

1. Inspect electrical 5 pin connector and seal of adapter
case. Replace if necessary.
2. Install gasket, transfer plate, and gasket.
3. Install adapter case valve body and seven 13 mm
screws. Tighten the screws to the specified torque.
Torque: 20 N m (15 lb ft)
4. Connect wiring harness assembly to converter clutch
solenoid and force motor.
5. Install oil pan gasket, oil pan, and twelve 10 mm
screws. Tighten the screws to the specified torque.
Torque: 11 N m (96 lb ft)
6. Fill transmission through the overfill screw hole of oil
pan, using ATF DEXRON –III, refer to Changing
Transmission Fluid in this section.
7. Connect battery ground cable.

Valve Body Assembly (Adapter Case)

AUTOMATIC TRANSMISSION (4L30–E)
12. Fill transmission through overfill screw hole of oil pan,
using ATF DEXRON –III., refer to Changing
Transmission Fluid in this section.
13. Connect battery ground cable.
7A–47