Engine Hood Switch; Unit/Transmitter Replacement - Isuzu 1999 RODEO Workshop Manual

8H–14 SECURITY AND LOCKS

Engine Hood Switch

Removal
1. Disconnect the battery ground cable.
2. Disconnect the connector.
3. Remove the engine hood switch (1).
Installation
To install, follow the removal steps in the reverse order.
Anti–theft & Keyless Entry Control

Unit/Transmitter Replacement

Anti–theft & Keyless Entry Control Unit
Replacement
1. Remove and install the control unit.
f Refer to Anti–theft & Keyless Entry Control Unit
Removal and Installation in this section.
2. Register ID code.
f Refer to ID Code Registration in this section.
3. Check that the keyless entry system works normally.
Transmitter Replacement
1. Prepare a new transmitter.
2. Regiter ID code.
f Refer to ID Code Registration in this section.
3. Check that the keyless entry system works normally.
Transmitter Battery Replacement
1. Remove a screw to remove the cover.
2. Remove the batteries.
3. Set the new batteries into the transmitter.
4. Install the cover to the transmitter.
5. Check that the keyless entry system works normally.
828RW002