Isuzu 1999 RODEO Workshop Manual page 1857

Inspection and Repair
Visual Check:
If any damage, deformation or wear is found, replace the
damaged part.
Operation Check:
Shake the piston and listen for check ball movement.
Movement indicates proper check ball operation.
Replace the piston if the check ball is missing or falls out.
Reassembly
1. Install piston assembly (10) into the second clutch
drum (11).
f Lubricate the lip seal with transmission fluid. Use
the J–23080–A second clutch piston installer to
protect the outer piston lip seal.
NOTE: Lip of the seal should point toward front of
transmission.
f Remove the installer.
AUTOMATIC TRANSMISSION (4L30–E)
2. Install twenty-two piston springs (9) and spring seat
(8) on the second clutch piston (10). Place retaining
ring (7) onto spring seat.
f Use the J–23327 compressor to compress the
piston springs.
NOTE: Do not let spring seat catch in ring groove.
f Remove the compressor.
3. Install waved plate (6) and clutch plates (5). Start with
a steel plate and alternate with lined plates.
f Align second clutch inner tangs.
4. Install spacer (4), with the fluted end toward clutch
plates.
5. Install retaining ring (3), ring gear (2) and retaining
ring (1).
247RS007
7A–75