On-Vehicle Service Camshaft Position (Cmp) Sensor - Isuzu 1999 RODEO Workshop Manual

On-Vehicle Service Camshaft
Position (CMP) Sensor
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the engine cover.
3. Remove the common chamber assembly.
Refer to Common Chamber in Engine Mechanical.
4. Disconnect the electrical connector to the CMP
sensor.
5. Remove the CMP retaining bolt from the side of left
cylinder head.
6. Remove the CMP sensor from the cylinder head.
Inspection Procedure
1. Inspect the sensor O-ring for cracks or leaks.
2. Replace the O-ring if it is worn or damaged.
3. Lubricate the new O-ring with engine oil.
RODEO 6VD1 3.2L ENGINE DRIVEABILITY AND EMISSIONS
014RW120
014RV053
4. Install the lubricated O-ring.
Installation Procedure
1. Install the CMP sensor in the cylinder head.
2. Install the CMP sensor retaining bolt.
Tighten
f Tighten the retaining screw to 9 N·m (78 lb in.).
3. Connect the electrical connector to the CMP sensor.
4. Install the common chamber assembly.
Refer to Common Chamber in Engine Mechanical.
5. Install the engine cover.
6. Connect the negative battery cable.
6E2–449
014RV053
014RW106