Isuzu 1999 RODEO Workshop Manual page 2423

8E–10 METER AND GAUGE
Removal
1. Disconnect the battery ground cable.
2. Remove the Dash Side Trim Panel –LH.
3. Remove the lower cover Assembly(1).
Refer to the Instrument Panel Assembly in Body
Structure section.
4. Remove the meter cluster Assembly(2).
Refer to the Instrument Panel Assembly in Body
Structure section.
Warning Light Bulb, Indicator Light Bulb, Illumination Light Bulb,
Removal
1. Disconnect the battery ground cable.
2. Remove the meter assembly(1).
Refer to the Meter Assembly removal steps in Meter
and Gauge section.
3. Hold the bulb socket by hand and rotate it
counterclockwise to remove the socket & bulb(2)
from the meter body.
5. Remove four fixing screws and disconnect the meter
CAUTION: The removed meter assembly should be
placed upright or with its face side up.
Installation
To install, follow the removal steps in the reverse order.
821RW253
A/T Indicator Light Bulb
Installation
To install, follow the removal steps in the reverse order.
connectors to remove the meter assembly(3).
825RW197
825RW059