Tools Required; Weather-Pack Connector - Isuzu 1999 RODEO Workshop Manual

Hide thumbs Also See for 1999 RODEO:

Table of Contents

RODEO 6VD1 3.2L ENGINE DRIVEABILITY AND EMISSIONS

3. Twist the wires as they were before starting this

4. Tape the wires with electrical tape. Hold in place.

Tools Required

J 28742-A Weather-Pack II Terminal Remover

Removal Procedure

A Weather-Pack connector can be identified by a rubber

seal at the rear of the connector. This engine room

connector protects against moisture and dirt, which could

from oxidation and deposits on the terminals.

protection is important, because of the low voltage and

the low amperage found in the electronic systems.

1. Open the secondary lock hinge on the connector.

2. Use tool J 28742-A or the equivalent to remove the

pin and the sleeve terminals. Push on J 28742-A to

NOTE: Do the use an ordinary pick or the terminal may

be bent or deformed. Unlike standard blade terminals,

these terminals cannot be straightened after they have

been improperly bent.

Show Quick Links

Table of Contents