Battery Warning Light; Testing The Battery Warning Light; Battery Warning Light Removal - Club Car 2009 Electric Precedent Maintenance And Service Manual

15

Battery Warning Light

3.3. Secure instrument panel to the dash assembly with three screws (1). Tighten screws to 1.8 ft-lb (2.5 N·m).
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first. Tighten
battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray (CCI P/N
1014305) to minimize corrosion.
702
Figure 15-1 Instrument Panel Removal
BATTERY WARNING LIGHT
See General Warnings on page 1-1.

TESTING THE BATTERY WARNING LIGHT

See Test Procedure 26 – Battery Warning Light on page 11-34 or 12-34.

BATTERY WARNING LIGHT REMOVAL

1. Disconnect the battery cables and discharge the controller as instructed. See WARNINGS "To avoid
unintentionally starting..." and "After disconnecting the batteries, wait 90 seconds..." in General
Warnings on page 1-1.
2. Remove instrument panel. See Key Switch Removal on page 15-1.
3. Disconnect the wires at the warning light.
4. Press the two retaining tabs (11) and remove the light from the center dash (Figure 15-3, Page 15-3).
Page 15-2 2009 Electric Precedent Maintenance and Service Manual
1
3
1
9
703
Figure 15-2 Key Switch
ELECTRICAL COMPONENTS
8
6