Table of Contents
Advertisement
Caution
Do not use anti puncture fluid or any
other item likely to obstruct air flow to
the
TPMS
sensor's
blockage to the air pressure orifice of
the TPMS sensor during operation will
cause the sensor to become blocked,
causing irreparable damage to the
TPMS sensor assembly.
Damage caused by the use of anti
puncture
fluid
maintenance is not considered a
manufacturing defect and will not be
covered under warranty.
Always have your tyres fitted by your
authorised Triumph dealer and inform
them that tyre pressure sensors are
fitted to the wheels.
Caution
An adhesive label is fitted to the wheel
rim to indicate the position of the tyre
pressure sensor.
Care must be taken when replacing
the tyres to prevent any damage to
the tyre pressure sensors.
Always have your tyres fitted by your
authorised Triumph dealer and inform
them that tyre pressure sensors are
fitted to the wheels.
The tyre pressures shown on the
instrument panel indicate the actual
tyre pressure at the time of selecting
the display. This may differ from the
inflation pressure set when the tyres
are cold because tyres become warmer
during riding, causing the air in the tyre
to expand and the pressure to increase.
The cold inflation pressures specified by
Triumph take account of this.
orifices.
Any
or
incorrect
GENERAL INFORMATION
The tyre pressures must only be
adjusted when the tyres are cold and
using an accurate tyre pressure gauge.
The tyre pressure display on the
instruments must not be used when
adjusting the tyre pressure. For the
recommended tyre pressures, see the
Specification section.
Tyre Pressure Sensor Batteries
When the battery voltage in a pressure
sensor is low, a message will be shown
in the instrument display and the TPMS
symbol or message will indicate which
wheel sensor has the low battery
voltage. If the batteries are completely
flat, only dashes will be shown in the
instrument
display,
warning light will be on and the TPMS
symbol will flash continuously. Contact
your authorised Triumph dealer to have
the sensor replaced and the new serial
number recorded in the spaces provided
in the Sensor Serial Number section.
With the ignition switch turned to the
ON position, if the TPMS symbol flashes
continuously or the TPMS warning light
remains on there is a fault with the
TPMS system. Contact your authorised
Triumph
dealer
rectified.
the
red
TPMS
to
have
the
fault
77
Advertisement
Table of Contents
