Adi_Ebiu_Cmd_Set_Sdram_Sctle; Adi_Ebiu_Sdram_Emren - Analog Devices VisualDSP++ 5.0 Service Manual

Setting Control Values in the EBIU Module
as the speed grade and configuration settings. The external memory bank
size must also be specified using the
command. Because Analog Devices EZ-KIT Lite boards include SDRAM
supplied by Micron, this information applies only to Micron parts. The
list of valid enumeration values are found in the API header file,
.
adi_pwr.h

ADI_EBIU_CMD_SET_SDRAM_SCTLE

This enumeration specifies if the SDRAM controller is enabled or disabled
and corresponds to the
ADI_EBIU_SDRAM_SCTLE_DISABLE
ADI_EBIU_SDRAM_SCTLE_ENABLE

ADI_EBIU_SDRAM_EMREN

This enumeration specifies that low power (2.5 V) SDRAM is used and
corresponds to the
ADI_EBIU_SDRAM_EMREN_DISABLE
ADI_EBIU_SDRAM_EMREN_ENABLE
The default value is specified by the following macro:
#define ADI_EBIU_SDRAM_EMREN_DEFAULT
ADI_EBIU_SDRAM_EMREN_DISABLE
4-40
ADI_EBIU_CMD_SET_SDRAM_BANK_SIZE
bit in the
SCTLE
bit in the
EMREN EBIU_SDGCTL
Mobile low power SDRAM is not present.
Mobile low power SDRAM is present.
VisualDSP++ 5.0 Device Drivers and System
Services Manual for Blackfin Processors
register.
EBIU_SDGCTL
Disable SDRAM controller.
Enable SDRAM controller.
register.