Adi_Pwr_Vr_Phywe; Adi_Pwr_Vr_Wake; Pm Module Macros - Analog Devices VisualDSP++ 5.0 Service Manual

PM Module Macros

ADI_PWR_VR_PHYWE

This data type defines the values for the
control register. If enabled, the voltage regulator can be awakened from
power-down by activity on the PHY interface.
ADI_PWR_VR_PHYWE_DISABLED
ADI_PWR_VR_PHYWE_ENABLED

ADI_PWR_VR_WAKE

This data type defines the values for the
control register. If enabled (
lator can be awakened from power-down (
upon an RTC interrupt or a low-going edge on the
ADI_PWR_VR_WAKE_DISABLED
ADI_PWR_VR_WAKE_ENABLED
PM Module Macros
Table 3-8 lists and describes PM module macros.
Table 3-8. PM Module Macros
Macro
ADI_PWR_VLEV_DEFAULT
ADI_PWR_VLEV_MIN
ADI_PWR_VLEV_MAX
ADI_PWR_VOLTS(V)
ADI_PWR_MILLIVOLTS(V)
3-56
PHYWE
Disable wakeup by PHY activity.
Enable wakeup by PHY activity.
bit in the voltage regulator
WAKE
ADI_PWR_VR_WAKE_ENABLED
ADI_PWR_VR_FREQ_POWERDOWN
Disables wakeup by RTC and
Enables wakeup by RTC and
Explanation
Default/reset voltage level
Minimum voltage level
Maximum voltage level
Returns the voltage in volts as a float for the given
level.
Returns an integer value of the voltage in millivolts
for the given level.
VisualDSP++ 5.0 Device Drivers and System
Services Manual for Blackfin Processors
bit in the voltage regulator
), the voltage regu-
pin.
RESET
.
RESET
.
RESET
ADI_PWR_VLEV_130
ADI_PWR_VLEV_085
ADI_PWR_VLEV_120
)