Connecting The Power Cord; Connecting The Interface Cable - Genicom 5050 User Manual

CONNECTING THE POWER CORD

CONNECTING THE INTERFACE CABLE

5050/5100 User's Manual
The 5050/5100 (50, 55 or 60 dBa) Cabinet Model printer is equipped
with an auto-switching power supply and can be connected to either
a 115V or 230V source without damage or manually changing a
switch setting.
The allowable voltage variation is ±15% and the allowable frequency
is 48 to 65 Hz.
A power cord is packed with the printer. Plug the female end of the
cord into the recessed connector at the rear of the printer. See Figure
2-2. Plug the other end into a compatible, properly grounded AC
outlet.
Avoid using AC circuits serving other equipment which may cause
chronic low voltage, noise interference, or power fluctuations. Data
loss may result.
The AC outlet must be rated for at least 10-ampere service.
Both a 25-pin RS-232C serial interface connector and a 36-pin
CENTRONICS parallel interface connector are standard on this
printer. Both connectors are located on the data connector plate on
the rear of the printer. See Figure 2-2.
25-PIN SERIAL
CONNECTOR
36-PIN PARALLEL
CONNECTOR
I/O CARD
INTERFACE SLOTS
FIGURE 2-2 REAR VIEW OF PRINTER
5050/5100 (55 dBa) MODEL
Note
4
POWER ON/OFF
(I/O) SWITCH
FUSE HOLDER
RECESSED CONNECTOR
POWER CORD
GEK-99044E