Twinax - Genicom 5050 User Manual

Expansion1

Twinax

Twinax
Emulation
Emulation
6408<
5050/5100 User's Manual
Twinax
This menu is used to configure the Twinax settings, Emulation,
Station Addr, and Buffer Size. These options are only visible with the
appropriate software loaded, SCS or IPDS, and the TX/CX optional
I/O card installed in either expansion slot 1 or 2. See Setup Menu
Map on page 206 in Appendix I for available options.
1. While in the Expansion 1/2 menu, press the ◄ (left) or ► (right)
menu browse keys until Twinax is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key. Twinax will be displayed in
the upper left corner of the LCD.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
setting is displayed in the lower right corner of the LCD.
4. Press the ▼ (down) menu browse key to access the options. Press
the Select key to enable/disable a setting. The < symbol will
immediately follow an enabled twinax setting.
5. Press the Clear, or ▲ (up) menu browse, key to exit this option.
87
Chapter 5. Using the Setup Menu