Top Print Ref - Genicom 5050 User Manual

Modify Format

Top Print Ref

Top Print Ref
By IN
Top Print Ref IN
00.0
5050/5100 User's Manual
Top Print Ref
This menu option is used to set the top print ref. The top print ref
may be set By Inches.
1. While in Modify Format menu, press the ◄ (left) or ► (right)
menu browse keys until Top Print Ref is displayed in the lower
right corner of the LCD.
2. Press the ▼ (down) menu browse key to access the Top Print Ref
options. Top Print Ref will be displayed in upper left corner of
LCD.
3. Press the Select key again to modify the setting. Notice the cursor
(underline) is now shown under the first digit. The four menu
browse keys revert to data entry operation. The horizontal ◄ ►
(left or right) keys position the cursor (underline) under the digit
to be changed; the vertical ▲ ▼ (up or down) keys
increment/decrement the selected digit by one.
4. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Pressing the Clear key does not erase the values entered, but does
allow the user to exit the User Set menu.
Repeat this section if further changes are necessary.
Note
59
Chapter 5. Using the Setup Menu