Vertical Format; Vertical Tabs - Genicom 5050 User Manual

VERTICAL FORMAT

Set Up
Vertical Format
Type Select
Vertical Tabs<

Vertical Tabs

Type Select
Vertical Tabs<
Vertical Tabs
By Lines
Vert Tab Lines
01:New
Vert Tab Lines
01:000
5050/5100 User's Manual
This menu is used to select either an emulation-dependent vertical
format unit (VFU) or a vertical tab table for vertical moves.
1. While in Set Up menu, press the ◄ (left) or ► (right) menu browse
key until Vertical Format is displayed in the upper left corner of
the LCD.
2. Press the ▼ (down) menu browse key to access the vertical format
submenu. Type Select is displayed in the upper left corner of the
LCD.
3. Press the ◄ (left) or ► (right) menu browse keys to select the
desired vertical format type.
The following describes the selections available.
This menu is used to clear or set the vertical tab. The vertical tab
length may be set By Lines, By Inches or Clear All Tabs.
The first two digits represent the tab ID and the last three digits
are the tab location. The number of tab IDs available is
dependent on the emulation selected. See "Horizontal/Vertical
Tab Id Maximum Slots" table in Appendix H.
1. While in Type Select menu, press the ▼ (down) menu browse key.
Vert Tab will be displayed in the upper left corner of the LCD.
(This step assumes Vertical Tabs is the currently selected setting.
If not, press the Select key to select Vertical Tabs.)
2. Press the ◄ (left) or ► (right) menu browse keys and select Clear
All Tabs, By Lines,or By Inches. Press the Select key to select one
of these options. Vert Tab Lines, or Vert Tab IN will be displayed in
the upper left corner of the LCD.
3. Press the Select key again to modify the vertical tab setting.
Notice the cursor (underline) is now shown under the first digit
and the default number is 000. The four menu browse keys revert
to data entry operation. The horizontal ◄ ► (left or right) keys
position the cursor (underline) under the digit to be changed; the
vertical ▲ ▼ (up or down) menu browse keys
increment/decrement the selected digit by one.
4. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Pressing the Clear key does not erase the values entered, but does
allow the user to exit the User Set menu.
Repeat this section if further changes are necessary.
Note
Note
137
Chapter 5. Using the Setup Menu