Beeper; Display; Keys - Genicom 5050 User Manual

Beeper

Display

Keys

5050/5100 User's Manual
The control panel beeper sounds momentarily when:
▪ A key is pressed.
▪ A BEL control code is received.
▪ A PAPER LOW condition exists.
▪ An EVFU loading error occurs. (For more information on the
EVFU, see the Programmer's Manual.)
▪ A hard fault occurs. (See Chapter 7 for an explanation of hard
faults.)
▪ If SCS or IPDS software is loaded in the printer, the beeper will
sound on receipt of an SCS or IPDS bell code.
The two row by sixteen-character LCD provide the following
information:
▪ The printer's status - Online, Local, Self-test, etc.
▪ Which menu or menu option is presently on display to assist in
making selections.
▪ Fault messages.
▪ If SCS or IPDS software is loaded in the printer, the display can
show coax and twinax status messages. Refer to the Setup Menu
| Interface Settgs | IBM Host Status.
The keys are raised rubber-type switches used to make menu
selections, clear faults, and position the paper. An explanation of the
keys' functions is given in the following section on "Operation of the
Control Panel."
7
Chapter 2.Getting Started