Installing The Paper Handling System; (55 Or 60 Dba Cabinet Models) - Genicom 5050 User Manual

INSTALLING THE PAPER HANDLING SYSTEM

(55 OR 60 dBa CABINET MODELS)

The paper handling system for this printer consists of an upper paper
rack and a paper shelf with wickets and a stacking aid.
See Figure 2-4.
The 5050/5100 (50 dBa) Cabinet Model has an internally
installed paper handling aid.
The paper shelf hangs on the back of the printer near the floor. The
paper rack hooks onto the two end wire loops protruding from the
rear paper exit.
Use the following procedures to install the paper handling system:
1. Hang the paper shelf on the back of the printer in the holes
2. Install the wickets on the shelf so the tightening knobs are facing
3. Slide the wickets along the shelf so the distance between the
4. Lay the V-shaped paper stacking aid on the shelf between the
5050/5100 User's Manual
provided as shown in Figure 2-4.
TIGHTENING
KNOB
FIGURE 2-4 PAPER HANDLING SYSTEM
5050/5100 (55 dBa) CABINET MODEL SHOWN
away from the area the paper will occupy.
wickets accommodates the length of the fanfold paper (form
length).
wickets. This stacking aid should be used when stacks of 1000 or
more forms are anticipated. See Figure 2-4.
Note
PAPER
SHELF
WIRE
10
UPPER
PAPER
RACK
WICKETS
V-STACKING
AID
PAPER
SHELF
GEK-99044E