Dcf Term; Ascii Driver; Print Direction - Genicom 5050 User Manual

IBM Format

DCF Term

DCF Term
00
IBM Format

ASCII Driver

ASCII Driver
Disable<
IBM Format

Print Direction

Print Direction
Forward<
5050/5100 User's Manual
DCF Term
This selects the DCF Term setting. See DCF 1 for additional
information.
1. While in the IBM Format menu, press the ◄ (left) or ► (right)
menu browse key until DCF Term is displayed in the lower right
corner of the LCD.
2. Press the Select key to configure the DCF Term options.
3. Notice the cursor (underline) is now shown under the first digit.
Use the horizontal ◄ ► (left or right) menu browse keys to
position the cursor (underline) under the digit to be changed; use
the vertical ▲ ▼ (up or down) menu browse keys to
increment/decrement the selected numeric digit by one.
4. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Repeat this section if further changes are necessary.
ASCII Driver
This enables/disables ASCII Driver. When enabled, this menu option
prevents commands in SCS jobs from changing control panel
selections of CPI, LPI, MPL, etc. The printer's SCS controller will not
send any Escape sequences to the print engine.
1. While in the IBM Format menu, press the ◄ (left) or ► (right)
menu browse key until ASCII Driver is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the ASCII Driver
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
Print Direction
This option sets the print direction to either Forward (default), left to
right or Reverse, right to left printing. Reverse is for languages that
need to be right based (i.e. Arabic).
4. While in the IBM Format menu, press the ◄ (left) or ► (right)
menu browse key until Print Direction is displayed in the lower
right corner of the LCD.
5. Press the ▼ (down) menu browse key to access the Print Direction
options.
6. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
Note
117
Chapter 5. Using the Setup Menu