Stop Bits; Baud Rate - Genicom 5050 User Manual

Serial Setup

Stop Bits

Stop Bits
1<
Serial Setup

Baud Rate

Baud Rate
1200
5050/5100 User's Manual
Stop Bits
This sub-menu is used to configure the number of stop bits per
character setting for the serial interface. Set the number of stop bits
equal to that of the host computer. There are two settings under the
Stop Bits option, 1 or 2.
1. While in the Serial Setup menu, press the ◄ (left) or ► (right)
menu browse key until Stop Bits is displayed in the lower right
corner of the display menu.
2. Press the ▼ (down) menu browse key. Stop Bits will be displayed
in the upper left corner of the LCD.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
selection is displayed in the lower right corner of the LCD. Press
the Select key to enable or disable an option. The < symbol will
now immediately follow the enabled option.
Baud Rate
This sub-menu is used to configure a baud rate setting for the serial
interface. See Set Up Menu Map on page 206 in Appendix I for a
complete listing of available selections.
Use the following procedures to enable/disable a baud rate setting:
1. While in the Serial Setup menu, press the ◄ (left) or ► (right)
menu browse key until Baud Rate is displayed in the lower right
corner of the display menu.
2. Press the ▼ (down) menu browse key. Baud Rate will be displayed
in the upper left corner of the LCD.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
selection is displayed in the lower right corner of the LCD. Press
the Select key to enable or disable an option. The < symbol will
now immediately follow the enabled option.
81
Chapter 5. Using the Setup Menu