Self-Test Error Messages - Genicom 5050 User Manual

Self-Test Error Messages

DISPLAY
Self Test
TTMI error
TTMI noresp
TTMI checksum
Shuttle Error
Loading-----
Please Wait......
5050/5100 User's Manual
Self-test diagnostics are run:
During the power-on sequence.
After initialization from the menus.
When requested from the host by the ESC Q escape sequence. (See
Programmer's Manual for information on escape sequences.)
After some menu options are changed (e.g. Coax and Twinax models).
The following table shows the display message, fault, and error
message. The fault column indicates which circuit board is defective.
The error message is used only in the ANSI emulation while
using the serial interface. When an ESC Q escape sequence is
received, the printer performs a self-test and sends the
appropriate error message to the host if a fault is found. DCS =
ESC P and ST = ESC \. See Programmer's Manual for information on
the ANSI emulation and escape sequences.
TABLE 7-6
Diagnostic Fault Codes
FAULT
Self-test in progress.
Invalid response from TTMI board.
No response from TTMI board.
TTMI board ROM checksum failure. Call for service
Shuttle cannot stabilize.
Self-test completed with no errors
found, printer software is loading.
Note
CORRECTIVE ACTION
None.
Call for service.
Call for service.
Check for paper jam or print gap
adjustment. If either condition
does not exist, call for service.
None.
160
GEK-99044E