Removing A Ribbon - Genicom 5050 User Manual

Removing a Ribbon

5050/5100 User's Manual
5. If the ribbon cartridge has a reinker, turn the reinker lever
clockwise to the ON position. If necessary, see Figure 2-21.
After the ribbon cartridge has been installed, the print gap, paper
tension, paper path, and top of form position must be set. See
"Setting the Print Gap" later in this chapter for more
information.
FIGURE 2-24 RIBBON LOCKING
1. Place the printer offline and raise the top cover.
2. Turn the print gap wheel to the LOAD position. If necessary, see
Figure 2-14
3. Turn the ribbon locking lever clockwise to the LOAD position. If
necessary, see Figure 2-24.
4. Lift the ribbon off the ribbon deck.
Note
RUN
LOAD
25
RIBBON LOCKING
LEVER IN RUN POSITION
Chapter 2.Getting Started