Modify Format; Format Name - Genicom 5050 User Manual

Modify Format

Format
Modify Format
Modify Format

Format Name

Modify Format
Default
5050/5100 User's Manual
This menu option allows the operator to modify a format.
1. While in Format menu, press ◄ (left) or ► (right) until Modify
Format is displayed in the lower right corner of the LCD.
2. Press the ▼ (down) menu browse key to access the Modify Format
options.
The following describes each of the selections available.
Format Name
This menu option allows the operator to change the selected format
name. The LCD will display the format selected from the control
panel using the Format key. If no previously saved format name
exists, the format will be displayed as Default.
Use unique format names when creating or modifying a format.
1. While in Modify Format menu, press the ◄ (left) or ► (right) menu
browse keys until Format Name is displayed in the lower right
corner of the LCD.
2. Press the Select key to select a Format Name option. Notice the
cursor (underline) beneath the currently selected character to be
changed.
3. In Format Name, the display switches to a mode where the
operator may enter any alphanumeric character. The four menu
browse keys revert to data entry operation. The horizontal ◄ ►
(left or right) keys position the cursor (underline) to the digit to be
changed; the vertical ▲ ▼ (up or down) keys
increment/decrement the selected digit by one. Alphanumeric
characters will display in place of the underlined digit
sequentially.
4. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Pressing the Clear key does not erase the values entered, but does
allow the user to exit the User Set menu.
Repeat this section if further changes are necessary.
Note
Note
52
GEK-99044E