Dp(Long); I/F Straps - Genicom 5050 User Manual

I/F Type

DP(Long)

I/F Straps

H Bits 01-32
H Bits 01-32
01
H Bits 01-32
01<
I/F Straps
Bits 01 - 32
Bits 01 - 32
01
Bits 01 - 32
01<
5050/5100 User's Manual
DP(Long)
This menu is used to enable/disable the I/F Straps for
DataProducts(Long Lines) I/O Card (optional interface card.) These
are also known as hardware straps. See the I/F Hardware Straps
table on page 187 in Appendix G for hardware strap descriptions.
Use the following procedures to access the DP(Long) option:
1. While in the I/F Type menu, press the ◄ (left) or ► (right) menu
browse key until DP(Long) is displayed in the lower right corner of
the LCD.
2. Press the ▼ (down) menu browse key to access the I/F Straps
options.
3. Press the ◄ (left) or ► (right) menu browse key until the range of
H Bits 01 – 32 or H Bits 33 - 64 is displayed in the lower right
corner of the display.
4. Press the Select key to access H Bits 01 – 32 or H Bits 33 – 64. H
Bits 01 - 32 or H Bits 33 - 64 will be displayed in the upper left
corner of the LCD.
5. Depending on the H Bits menu selected, use the ◄ (left) or ►
(right) menu browse key until the desired H Bit strap is displayed
(01 - 32 or 33 - 64.) Press the Select key to enable/disable an H
Bit strap. The < symbol will immediately follow an enabled H Bit
strap.
6. Press the Clear, or ▲ (up) menu browse, key to exit this menu.
I/F Straps
This menu is used to enable/disable the I/F Straps for the Legacy
Parallel I/O card (optional interface card.) These are also known as
software straps. See the I/F Software Straps Table on page 188 in
Appendix G for additional information.
1. While in the Legacy Parallel menu, press the ◄ (left) or ► (right)
menu browse key until I/F Straps is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the I/F Straps. I/F
Straps will be displayed in the upper left corner of the LCD.
3. Press the ◄ (left) or ► (right) menu browse key until Bits 01 - 32
or Bits 33 - 64 is displayed in the lower right corner of the LCD.
4. Press the Select key to access Bits 01 - 32 or Bits 33 - 64.
5. Depending on the Bits menu selected, use the ◄ (left) or ► (right)
menu browse key until the desired Bit strap is displayed (01 - 32
or 33 - 64.) Press the Select key to enable/disable a Bit strap. The
< symbol will immediately follow an enabled Bit strap.
6. Press the Clear, or ▲ (up) menu browse, key to exit this menu.
85
Chapter 5. Using the Setup Menu